Make certain you have the 200vdc ( b-boost) on the crt pcb.The C of video outputs should have 130-200vdc on them.That source comes off the flyback.HTH Country TV Ron Miller 484 FM444 S. Inez,TX 77968-5002 V.(361)782-6419. F.(361)782-9149 e-mail: rlmbkm@xxxxxxxx ----- Original Message ----- From: "res0vjlk" <electronic.service@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, November 16, 2002 2:08 PM Subject: [TechAssist] SONY KV-27S40, Shuts down within 20 seconds, > > > Hello techs, > > This is most likely a CRT problem,need to confirm. > > Set turns on,brightness increases with retrace lines,then shuts down. > > Power indicator blinks twice.service > codes says high current draw. > > Any known fix besides replacing,rejuvenating CRT? > > Thanks, > > Marcello for > > Electronics Service Inc. > 808 841-1560 > www.pinoyelectronics.com > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/