Jim, Thank you. Bill -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of Jim Shupe Sent: Thursday, April 08, 2004 3:56 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Re: SAMPO SME-23DV3N visable retrace William... Caps..especially the doubler filter off the flyback diode(usually from vert B+ to Vcc2). This cap is responsible for most failures of vertical output IC's, in my experience(all brands). Jim Shupe, CET Lloyd's TV Yucca Valley, CA --- William Koscielniak <wkoscielniak@xxxxxxxxxxxx> wrote: > This is a SAMPO 32" monitor. Came in with no > Vertical. There was just a the > horizontal. Changed the Vertical driver and this > corrected the no vertical. > If there is signal input AV1 or AV2 have a normal > display, If there is a > blue screen indicating no signal there is a retrace > displayed on the upper > half of the blue display. Any suggestions?? Two > SME-23DV3Ns have just been > thru repair for HOT failure. > > (BILL)William Koscielniak AV Electronic Technician > St. Lawrence / LRC BOCES > 7229 State Highway 56 > Norwood, NY 13668 > > Phone (315) 353-6684 Ext 216 > FAX (315) 353-5504 > > > ---------------------------------------------------------------------------- - > Lost Password: > http://www.tech-assist.org and select "Login > Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ---------------------------------------------------------------------------- - Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/