Heat sink isolators ok??? Cm2k >From: "Ray Lufkin" <Rlufkin@xxxxxxxxxxxxxxx> >Reply-To: techassist@xxxxxxxxxxxxx >To: <techassist@xxxxxxxxxxxxx> >Subject: [TechAssist] Re: Realistic Stereo Receiver STA-2100 >Date: Mon, 12 Nov 2001 21:07:56 -0500 > > >You have a dc offest oin the base of your outputs. Check to see which >polarity. To work on this unit lift all output leads and see if you can >signal trace a sine wave thru the circuit. See where it gets bad. Should >be >able to see good signal drive on pad of lifted base on putputs. > > >----- Original Message ----- >From: "Tel-Tek Electronics" <teltek@xxxxxxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Monday, November 12, 2001 3:57 PM >Subject: [TechAssist] Re: Realistic Stereo Receiver STA-2100 > > > > > > Thanks Frank; > > I have isolated it to Right side. > > If I remove the B+ from one side, (unit has two modules, relay will >click > > and good side will work). > > Have checked the transistors on the defective side, 4 mounted on heat >sink, > > and small drivers on the same module. Have checked them in circuit, and >are > > not shorted, although not sure if one may be leaky. > > Any thing I should look for. > > > > Thanks. > > > > -Ed- > > teltek@xxxxxxxxxxx > > TEL-TEK ELECTRONICS. > > > > > > > > > > > > ----- Original Message ----- > > From: "RS Tek Inc" <rstek@xxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Monday, November 12, 2001 9:10 AM > > Subject: [TechAssist] Re: Realistic Stereo Receiver STA-2100 > > > > > > > > > > Check the power supply that runs the protection circuit. They can go >bad, > > > also the transistor that sinks the relay can open up as well. See if >you > > > have dc on the speaker contacts that feed the relay. > > > Good Luck > > > Frank > > > ----- Original Message ----- > > > From: "Tel-Tek Electronics" <teltek@xxxxxxxxxxx> > > > To: "AAAA TECH-ASSIST" <techassist@xxxxxxxxxxxxx> > > > Sent: Monday, November 12, 2001 1:44 PM > > > Subject: [TechAssist] Realistic Stereo Receiver STA-2100 > > > > > > > > > > > > > > Anybody worked on these old Stereos. > > > > Customer complained of relay cutting out periodically. > > > > Now relay won't activate at all. All O/P transistors good. -57 and >+57 > > > volts > > > > on collectors. No fuses blown. Have 24 volts at relay coil. About >all >I > > > can > > > > say, since I have no Circuit for this. > > > > > > > > Thanks; > > > > > > > > -Ed- > > > > > > > > > > > > teltek@xxxxxxxxxxx > > > > TEL-TEK ELECTRONICS. > > > > > > > > > > > > > > > > > > > > > > > > > > > > ***************************************** > > > > Help make your TechAssist online repair tips > > > > database better! Submit your fixes here: > > > > http://www.circuitwork.com/techassist/tip/#tips > > > > ***************************************** > > > > To UNSUBSCRIBE write to: > > > > techassist-request@xxxxxxxxxxxxx > > > > with unsubscribe in the subject line. > > > > > > > > > > > > > > ***************************************** > > > Help make your TechAssist online repair tips > > > database better! Submit your fixes here: > > > http://www.circuitwork.com/techassist/tip/#tips > > > ***************************************** > > > To UNSUBSCRIBE write to: > > > techassist-request@xxxxxxxxxxxxx > > > with unsubscribe in the subject line. > > > > > > > ***************************************** > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > ***************************************** > > To UNSUBSCRIBE write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > >***************************************** >Help make your TechAssist online repair tips >database better! Submit your fixes here: >http://www.circuitwork.com/techassist/tip/#tips >***************************************** >To UNSUBSCRIBE write to: >techassist-request@xxxxxxxxxxxxx >with unsubscribe in the subject line. _________________________________________________________________ Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp ***************************************** Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips ***************************************** To UNSUBSCRIBE write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.