will ck these out. thanks Clint, gary Gary Chambers Chambers T V Bradenton,Florida Since 1982 ----- Original Message ----- From: "TechAssist Admin." <techassist@xxxxxxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, November 02, 2001 1:17 PM Subject: [TechAssist] Re: RCA VCR VR528/VG4039(GE VERSION) INTERMITTANT POWER > > Gary see if you have R1205, R102, R103, IC7501, C14 (in PS, > 220uf 16v), and D01, D105, D1103, D1104 & D106 (could be bad > even if it checks good). > -Clint > > God Bless Us All > Clint Hamilton, Owner > http://OrpheusComputing.com > sales@xxxxxxxxxxxxxxxxxxxx > Fax: 209-882-9602 > TechAssist Administration > http://tech-assist.org > techassist@xxxxxxxxxxxxx > 4orpheus@xxxxxxxxxxxxx (alternates) > orpheuscomputing@xxxxxxxxx > pchardware@xxxxxxxxxxxx > (PLEASE include previous correspondence > if replying to this email!!) > > ----- Original Message ----- > From: "GJCHAMBERS" <gjchambers@xxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, October 31, 2001 3:48 PM > Subject: [TechAssist] RCA VCR VR528/VG4039(GE VERSION) > INTERMITTANT POWER > > > This vcr had diodes dpo26 and dp027 shorted,after replacing > them vcr now blinks on and off about once a second.the > display blinks at this rate as well. > i replaced cp007,cp008, ipoo1,ip003. > also ck'ed the resistors on primary side of smps transformer > and all ck ok. > all voltages on secondary pulse up and down as well. > acts sorta like the ones that used that 22 uf bipolar cap in > primary. > sometimes will stay on,untill you push a button, then starts > cycling again. > any ideas? > thanks, > gary > Gary Chambers > Chambers T V > Bradenton,Florida > Since 1982 > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.