Ralph, Thanks for the reply. As I stated in my original message, I did go into the parental lock and made sure it was set to off, etc. Any further ideas? Thanks. Gary Ralph Dorsey wrote: > > it's in the parental control (lock ) mode. Go into the main menu and you > can set it to off some where in the menu. > > Gary McCartney wrote: > > >This is my first repair of CTC197 chassis. Set came in dead. Replaced > >HOT, flyback and a couple resistors and soldered the tuner. Works fine > >now. Only problem is that the menu button on the front panel does > >nothing. All the other front panel buttons operate normally. > > > >I measured continuity of the menu switch when closed- is ok. Followed > >the switch path through R117 to the micro IC and all traces are ok. The > >menu button on the remote does work as normal. I went into the parental > >control and made sure the front panel buttons were enabled. Then I > >disabled them and then re-enabled them again. No difference. The TV > >guide and PIP seem to be ok. > > > >Is this an eeprom problem? If so, can I correct it without a Chipper > >Checker? I do have a regular eeprom programmer if someone knows what > >byte would need to be reset or whatever. > > > > > >One other question, I've read where there is an RCA bulletin to replace > >a resistor and cap when flyback is changed. My flyback number is 237502. > >It did not come with any bulletin regarding this. Does this mean my > >version of the chassis is exempt from the alteration? > > > > > >Thanks for any help. > > > > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. -- Gary McCartney McCartney Electronics 7134 Fife Rd, RR 7 Guelph Ontario Canada N1H 6J4 Fax: (519)821-1530 email: number63@xxxxxxxxxxxxx ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.