did you change the hot? al marquardt ampm@xxxxxxx ----- Original Message ----- From: "R Herring" <supertek66@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, December 06, 2001 8:29 PM Subject: [TechAssist] Re: RCA G35300WK CTC169BA Blowing Pincushion > > Hey group, > this dog is a pain. I changed C4705 now read normal +26v at U4801 pin 10 > with horizontal yoke disconnected all is well, vertical waveforms are normal > at TP45 (vert yoke), horizontal waveforms are normal at Q4401 base. All run > voltages are within tolerance. When turn off connect hor yoke and power up > CR4401 pops. > Besides parts listed in previous post have also replaced CR4805, Q4804, > C4801, CR4806, C4705 > Has anyone seen this or have a good idea what else to look for? > I'm out of patience and so is my customer. > TIA > Robert > H&H Electronics Inc > supertek66@xxxxxxxxxxx > robert_herring@xxxxxxxx > > ----- Original Message ----- > From: "R Herring" <supertek66@xxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Thursday, November 29, 2001 10:48 PM > Subject: [TechAssist] RCA G35300WK CTC169BA Blowing Pincushion > > > > HELP ! > > this dog is really bite'n me > > I repaired power supply usual C4102,C4105,C4108,CR4118,C4143,C4145. > > When powered up R4719 at C-Q4705 on/off switch smoked and found Q4702,and > CR4401 damper shorted, > > so replaced those and C4401,C4402,CR4402. > > Now U4801, Q4802, CR4401 blows their top when powered up if yoke > connected. > > Standby volts +153, +7.4, +13.5,+17 and -17 > > Will come on and run if leave horizontal yoke disconnected. > > Run voltage +143.3 others ok except +26v off T4401 pin 10 reads +36v > > now needs U4801,Q4802,CR4401,CR4805,Q4804 > > Have tried subbing different crt/yoke with same results. > > Please anyone that may have seen this or have idea my ears are open. > > TIA > > Robert > > H&H Electronics Inc > > supertek66@xxxxxxxxxxx > > robert_herring@xxxxxxxx > > > > ================================= > > Help make your TechAssist database better! > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > ================================= > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe