Kevin: Two thoughts. CR4120 on q4101e appears to be a reference diode. Second, if the set is a "smokers" set, R4117 could be contaminated. The schematic says it is sealed, but I don't know how well. From RCAs FixFinder: R4118 had two entries for low B+ Wayne Vanaman Omega Electronics 6904 W Fairfield Dr Pensacola, Fl. 32506-3310 Wayne@xxxxxxxxxxxxxxxxxxxxx WWW.PensacolaTVRepair.Com 850-456-5995 voice 850-458-6369 fax Kevin wrote: > This is the last kick at the can. Picture is fine when first turned on, > but slowly the picture comes in from the top and bottom and sides, and > gets dark and blurry. B+ starts off at 129 volts (correct from SM) and > slowly drops to 116 volts after about 2 hours (sometimes more, sometimes > less). I replaced SCR4101, HOT Q4401, and 4 transistors (Q4101/2/3/4) > in the error detection circuit. I also checked all the caps in the P/S > and horizontal and used half a can of cold spray. Is there anything > else I can check for? I am suspecting the flyback or picture tube but I > don't have a working CTC167 chassis to confirm my diagnosis. Does > anyone have a working CTC167 chassis? Thanks. > > Kevin Wilks > Kevin's TV & Video Repair > Penticton BC Canada > kevintv@xxxxxxx > > > > ----------------------------------------------------------------------------- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/