I do think so, provided you check the (black round) fuses in the (+) and (-) lines and make sure the voltages reach the ICs (I believe they are +/- 32v) At 01:57 p.m. 05/08/03 -0400, you wrote: >Hi, > >I have bad convergance on this set (chassis # PTV835). >By bad convergance, I mean, practically no convergance correction. The red >has the familiar "hook" in it. > >Can I get away with changing just the convergance outs on this? Or, do I >need to change the entire board, like on one of the older models that I >remember? > >John Myers >Myers TV Service Co. Since 1984 >Alliance, OH >Voice: 330-821-6545 >myerstv@xxxxxxxx >http://members.ebay.com/aboutme/tvguy07/ >http://members.ebay.com/aboutme/threads_r_us/ > > >***************************************************************************** >Classifieds! Buy or Sell! >http://sell.tech-assist.org >The Tech Address Book: >http://www.tech-assist.org/secure/tip/contact.htm >Add a Repair Tip Here, or Change/Remove your Email Address: >http://www.tech-assist.org/secure/tip/main.htm >Lost Password: >http://www.tech-assist.org and select "Lost your Login Info?". >Email Archives: >//www.freelists.org/archives/techassist/ Jorge Camboni, GY Electronics, Richardson, TX ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/