Bruce, Just remove the speaker front panel and the convergence board is accesible from the front. Gonzalo N. Arrivas, CET Pittsburg, CA http://www.etechhelponline.com Tel/Fax: 925-432-2057 If the Tech Site is Down. go to the below address to access. the following: Tech Message Board: http://members.sitegadgets.com/gnaenter8/board.html Electronics Tech Forum at SmartGroup: http://www.smartgroups.com/group/group.cfm?GID=255346 ----- Original Message ----- From: "Bruce Tiedeman" <btied@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, September 27, 2001 9:33 AM Subject: [TechAssist] PTK 169 PEC Projection (P60752EB) Fixed!!! > > I did not get to the customers house , with some direction he adjusted the > centering tabs on the back of the CRT (Green Gun) and it solved the problem > so he says. > > I probably moved it slightly causing the problem with the original repair.. > > My repair fee for the original job was very good so it did not bother me on > the call back. > > thanks for all the feed back on this and to Tech line Indy for the help > > The only thing I am not sure of, is how you take off the front of the > Projection to get at the convergence panel would be good to know for next > time.. > > Bruce. > B&T Electronics. > > > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.