This fixes most PIP Module problems........ Replace C7001, C7026, C7036, C7001 Caps On The Pip Board. Also Put Jumper Wire From + Side Of C7001 To Q7003 Emitter . Bypass module first to see if PIP is the problem. Remove PIP module,Use capacitors to jumper pins 5&11 and 7&9 of the VP connector. 2.2uF at 50v will work. I've seen others use different values,but any value I've tried(1uF,4.7uF) works fine. Peggs At 06:23 PM 1/7/03 -0500, Nova Service Center wrote: >Hi everyone, > I have a Mitsubishi 35" (CS-35301). The video roles vertically. It is probably a couple of capacitors on video/PIP board. Does anyone know which cap's need to be replaced? > >Thanks, > >Nova Service Center >PO Box 2515 >Gaithersburg, MD 20886 >240-632-2994 > >------------------------------------------ >Submit A Repair Tip For Everyone Here: >http://www.tech-assist.org/secure/tip/main.html >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > Peggs' Electronics 1519 West 2nd Street Owensboro,KY 42301 270-926-4968 fax 270-686-7399 ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html