Tim, Check the x-ray protection circuit voltage level might be kicking in due to excessive HV to 2nd anode caused by malfunction in power supply regulator circuit. George Afana Electronics Moreno Valley, CA ----- Original Message ----- From: "Tim Poole" <tdp13158@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, August 26, 2003 10:03 PM Subject: [TechAssist] Mits VS-50604 > I am trying to see if anyone has run into this problem. This set comes on, > hv comes up then shuts down. Replaced regulator, checked flyback,secondary, > nothing wrong. Any Ideas? > > Tim Poole pooletim@xxxxxxxxxxx tdp13158@xxxxxxxxxxx > dba A-Mobile TV Shop & Precision TV Service > 17626 Shady Lane > Fredericktown, Ohio 43019 > > 419-756-3443 > 740-694-8585 > fax 740-694-1032 > > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/