After you checked the caps, scope it for proper drive level to vertical IC and verify it has the correct DC voltage applied. George Afana Electronics Moreno Valley, CA ----- Original Message ----- From: <meservice98520@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Monday, August 18, 2003 11:04 AM Subject: [TechAssist] Mits CS-35405 vert short > Short~4" top and bottom. Good linearity. Sides in slightly with some pin distrn. Changed Eprom, vert out, esr'd caps in power supply and sweep. Service menu adj no help. > > The Old Guy > metvservice.com > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/