Hi Techs, I have a Mitsubishi VS-4544 here that has bad connections on the small PCB mounted to the yokes. Where do these get bad connections? Is it only on the yoke connector or could there be bad connections elsewhere on the PCB. Reason I ask is I can get to the yoke connector to solder it but don't see how I could get to the rest of the board to even inspect the connections. The picture goes away on this and I just lightly tapped one of the yoke plugs and it popped back on... Joel Jacobs Ohio Consumer Electronics Pickerington Ohio 614-833-9696 ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/