Walter Check C432 That's been going bad a lot Richard ----- Original Message ----- From: walter wood <wwood_38478@xxxxxxxxx> To: Tech Assist <techassist@xxxxxxxxxxxxx> Sent: Thursday, March 21, 2002 8:54 PM Subject: [TechAssist] Magnavox 25 Y105 Dead/Sams 3370 > > > > > > This set was supposedly lightning. > > Replaced Q400; IC410, Q502, and F401. All bad. > > Replaced C432 just because. > > Set checks ok for standby voltages with 172 volts > > on pin 3 of IC410 and collector Q400. > > Around 16 volts on pin 2 and 4 of IC 410 and base > > and emitter Q400. > > When turned on, high voltage goes to almost 25k > > and > > set cuts off. > > The strange part is that Emitter an Base of Q400 > > and pins 2 and 4 are at 131 volts at this point. > > Normal run voltage. > > BUT Collector Q400 and pin 3 of IC410 are at 172 > > volts, Not , according to my schematics, normal > > run. > > I have also checked R424,406,432,437,524, and > > R504. > > > > Set can be turned off and back on, but will not > > stay on, and after several tries, has to be un > > plugged, to continue. I find nothing in the 3 > > tips > > programs I have. > > Hope someone has some ideas. These sets are > > usually > > so easy. > > Thanks > > Walter > > > > ===== > Walter Wood > Future Tech Home Center > 2786 Hwy. 43 N. > Lawrenceburg Tn. 38464 > 931-829-3337 > Fax 931-829-4044 > mailto:wwood_38478@xxxxxxxxx > > __________________________________________________ > Do You Yahoo!? > Yahoo! Movies - coverage of the 74th Academy Awards® > http://movies.yahoo.com/ > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.