Carefully measure all resistors in vertical circuit I have had same problem but can't find notes as to what resistor fixed Robert tvservice@xxxxxxxxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "John Mielke" <maintv2002@xxxxxxxxxxxxx> To: "Tech assist" <techassist@xxxxxxxxxxxxx> Sent: Monday, December 09, 2002 6:20 PM Subject: [TechAssist] Mag 32K800 vertical is off center. > > I have a Magnavox TP3285-C129 with a chassis 32K800-7591 made in 2001. > The vertical is off center to the top. Getting into the SAM menu lets > me adust the ver-shift parameter from 0 to 63 with 63 being the best but > the picture is still too high. The pix does move as I adjust it and the > height appears good. The vertical output (STV9379F) has the following DC > voltages: > 1 +0.6v > 2 +12v > 3 +52v > 4 -13v > 5 +1.2v > 6 +12v > 7 +0.6 > I do not have a service manual or a new output chip. Could the output > IC be causing this? What else could cause it? Thanks for your reply. > John. > > -- > John Mielke > Main TV > Longmont,Co > 303 776 6955 > maintv2002@xxxxxxxxxxxxx > > > ------------------------------------------ > Submit A Repair Tip For Everyone Here: > http://www.tech-assist.org/secure/tip/main.html > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > > > ------------------------------------------ Submit A Repair Tip For Everyone Here: http://www.tech-assist.org/secure/tip/main.html ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html