Hello all, I have a CS-20203 (Looks like it was made by sharp on the inside. When did Mits start buying stuff from other manufactures?) Unit turns on then right back off. B+ is 122 Volts which is correct as far as I can tell (There is an adjustment for the B+ labeled 122V Adj) Because the B+ was ok. I forced the unit on by jumping the relay. Unit came on and stayed on.Turning up the G2 showed a full raster with no anomalies. Turning the processor on the unit still shut down. I am thinking it has a X-Ray protect problem. Anyone with a Tip or a print? Any help is appreciated! Good luck, God Bless Bill McFarland DMC Electronics ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.