If you have a scope check the SCL and SDA lines. Sometimes something loads one or the other down and it really screws up the system control micro. The last one I had it tuned out to be the tuner - I unsoldered the SDA and SCL at the tuner and the signal returned to 5v amplitude - changed the tuner and it was fixed.. Joel Jacobs Ohio Consumer Electronics Pickerington, Ohio ----- Original Message ----- From: "Bil Green" <tv.vcrrepair@xxxxxxxxxxx> To: ".TECHASSIST @ freelists . org" <techassist@xxxxxxxxxxxxx> Sent: Tuesday, March 29, 2005 3:41 PM Subject: [TechAssist] KV-27FS100 - No control of Vol, Ch, etc. > Sony KV-27FS100 > > Set turns on when plugged in > > Channel numbers rapidly advance, but the picture does not change. > > Can't change channels, volume, turn set off or operate any other > controls. > > Bil > > PC 1000 > Mammoth Lakes, CA > 760-924-1000 > M-Pulse 5000 magnetic pulse generator > http://www.heal-me.com.au/m-pulse5000.htm > > -------------------------------------------------------------------------- --- > This Email List is Public. Remove: http://www.tech-assist.org/remove.htm > Lost Password: http://www.tech-assist.org and select "Login Problems?". > Email Archives: //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/