Nice site! You can even learn how to CLEAN HEADS here, wow, everybody take a look! Sorry, just had to. Jim Myers jr.myers@xxxxxxxxxxx ----- Original Message ----- From: "Jeff Dougherty" <jeff@xxxxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, November 30, 2001 4:23 PM Subject: [TechAssist] Re: Frustrated Tech --- Philips Magnavox TV/VCR Combo > > Steven, > It may take you some time, but why don't you go to this site, and search for > a picture that looks like your unit. A model number would be lots help. > http://www.diyvcrparts.com/cgibin/web_store/web_store.cgi > If shingin a light in the sensors does not shut it off, you have a weak/dead > LED or dirty prism. > Jeff > mailto:Jeff@xxxxxxxxxxxxxxxxxx www.9-11-2001tragedy.com > FAX 1-413-280-0677 > Intrepid Video & Electronics > Harrisburg, PA 17111 > 717-909-8844 > www.intrepid-video.com www.tech-repair.net www.thetoolcaddy.com > ----- Original Message ----- > From: <Demers_Steve@xxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Friday, November 30, 2001 7:35 AM > Subject: [TechAssist] Frustrated Tech --- Philips Magnavox TV/VCR Combo > > > > > > Well..Were should I start.... > > > > I still haven't found out a model # for the TV/VCR combo unit.... I've > just > > about called every person on earth and one knows anything > > Tried to use Philips's 900 (900-896-8324) number but didn't get > anything... > > I guess that number is not in service.?.?.? Go figure..! > > So I gambled and replaced both IR LED's and the center LED. Also I cleaned > > the mode switch. > > > > Result = Same problem as before > > > > Symtoms = Attempts to eject tape automatically then 10 seconds later.... > > Good bye.. > > > > TV screen message = Stop then C or T Eject > > > > The only way I can prevent it from shutting off is by shining a light into > > the start sensor(At least I think its start sensor) > > > > I have voltage readings at both sensors (Above 4.6 v) > > > > I've just about had it with this unit....! > > > > **Here's some internal numbers** > > > > Monitor Make=FUNAI > > Model # A48KRD89X > > Serial # 803241687 > > > > Circuit Board # BB5900F01012 (Part #...?) > > > > VCR Chassis # MK7-F1(Part #...?) > > > > > > Please help...Any suggestion would be helpful. > > > > Steven > > > > > > > ----- Original Message ----- > > > From: <Demers_Steve@xxxxxxx> > > > To: <techassist@xxxxxxxxxxxxx> > > > Sent: Tuesday, November 20, 2001 7:23 AM > > > Subject: [TechAssist] Philips Magnavox TV/VCR Combo > > > > > > > > > > > > I'm looking for some information on a Philips Magnavox TV/VCR Combo > > > unit..... The only thing is... I don't have a model number. The model > > > number > > > sticker has been ripped off. > > > > > > I "think" this is the model number > > > Philips Magnavox CCA192AT 19" TV/VCR Combo > > > From whats left of the sticker off the back of the TV's Shell. It > appears > > > the unit was manufactured in 1998. Is there anything else I can use to > pin > > > point the model number of this unit..? For instance, model number/serial > > > off > > > the circuit board, etc. > > > > > > QUESTION: > > > The unit faults ever time its turned on.. It appears to be a sensor > > > problem > > > on the VCR.. At least I think... The VCR attempts too eject tape when > > > there > > > no tape installed. Then approx. 10 mins later the unit faults and shuts > > > off... Any suggestions on what I can check right away? > > > Thanks, > > > Steven Demers > > > ================================= > > > Help make your TechAssist database better! > > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > > ================================= > > > To UNSUBSCRIBE your email address, click here: > > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > > > > > ================================= > > Help make your TechAssist database better! > > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > > ================================= > > To UNSUBSCRIBE your email address, click here: > > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > > > > > ================================= > Help make your TechAssist database better! > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips > ================================= > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > > ================================= Help make your TechAssist database better! Submit your fixes here: http://circuitwork.com/techassist/tip/#tips ================================= To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe