Service mode access for this set is different than the instructions in the service manual. Press and hold power and input on the set till the set turns on then change the 000 value to 020 using the > key, then use the ^ to select the parameters according to the service manual changing the data with the < and > as needed. ******************************************************************************************************************* Since 1972 Jim Myers Telrad Electronics Fort Wayne, Indiana Jim Myers wrote: > I have this 32UX01S Hitachi repaired from a dead set condition and it > looks like all it really needs is the vertical size adjusted. There is > an adjustment code table in the service manual and instructions on > accessing the service mode but the set does not seem to do what the > manual says it should. I can't find the adjustments codes that are > listed and when I change anything starting with a V the picture geometry > does not change. The EEPROM was replaced, the original EEPROM causes the > controls to function very sluggishly so it probably is not practical to > get the original data. Is there a way to do this that works when the > service manual makes no sense? > Thanks, > ******************************************************************************************************************* > Since 1972 > Jim Myers > Telrad Electronics > Fort Wayne, Indiana > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/