This case should help. Loose Connections On And Broken Copper Trace At Resistor, R4703, Crt Filament Line From Flyback Pin 5. Then Found R4703 (3.3 Ohm 3w) Was Intermittently Opening. Jeff Stielau Shoreline Electronics Repair 125 Beech Tree Lane Westbrook, CT 06498 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ----- Original Message ----- From: "Terry Joseph Hutchison" <sony1@xxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, February 26, 2002 9:48 AM Subject: [TechAssist] CPTK169PEB no rastor > > This set has HV and screen voltage. CRT filaments are not lite. Have > checked database and looked for cracked trace paths(none). Crt drive > transistors(Q1F) on each tube seem to be in a no load condition. I have > 201 vdc on collectors, 5 vdc on emitters and .783vdc on base of each. > Suspect that I am missing 10 vdc to base. Would appreciate any help. > Terry > ------------------------------------------ > Make your TechAssist database better! > Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ > ------------------------------------------ > To UNSUBSCRIBE your email address, click here: > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe > Or send a BLANK email with unsubscribe in the > SUBJECT field to the address above. > > ------------------------------------------ Make your TechAssist database better! Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To UNSUBSCRIBE your email address, click here: mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe Or send a BLANK email with unsubscribe in the SUBJECT field to the address above.