Works for me. Guess I could have replied through the samba but thought it would be easier to send direct. --- On Wed, 3/25/09, Eric Woodall <eric@xxxxxxxxxxxxxx> wrote: From: Eric Woodall <eric@xxxxxxxxxxxxxx> Subject: [tcb] Re: Cargo door plate To: tcb@xxxxxxxxxxxxx Date: Wednesday, March 25, 2009, 9:47 AM Sounds right sammie. I moved you picture to my web server so that I could link to it in theSamba thread. Hope you don't mind... sammie smith wrote: > Eric: The best I could measure the square holes are exactly in the > center of the plate front to back. My measurement shows exactly 9mm > from both the inside and outside edges with the holes 15mm square and > the plate. 9mm to hole from front, 15mm hole, 9mm to back = the width > of the plate, 33mm. > > The front of the plate has a very slight bend down over the edge of > the cargo floor. > > --- On *Wed, 3/25/09, Eric Woodall /<eric@xxxxxxxxxxxxxx>/* wrote: > > > From: Eric Woodall <eric@xxxxxxxxxxxxxx> > Subject: [tcb] Re: Cargo door plate > To: tcb@xxxxxxxxxxxxx > Date: Wednesday, March 25, 2009, 9:01 AM > > Sammie, going by memory it looks like the one that I have has the > squares closer to the inside edge. > This would be why they don't fit. > Kelly Brown was cool about sending me a new one. > Hopefully it was just made wrong and not a bad fit on the panels > that I > have already installed. > Thanks again for the picture. > > Eric > > sammie smith wrote: > > Mark/Eric: Did you guys get the info that I sent on the striker > plate? > > > > >