That's great news, it should save a lot of time and work. 99 cents is an
amazing price for a steel nozzle.
On Sun, Sep 17, 2017 at 8:18 PM, Rick Maschek <dmarc-noreply@xxxxxxxxxxxxx>
wrote:
We did similar but for a much larger motor and it worked fine: Worlds
Largest Sugar Rocket Motor Test.
<https://www.youtube.com/watch?v=eeOVhQKnTfg>
Worlds Largest Sugar Rocket Motor Test.
2 grains 12x20 260 pounds of propellan. sim was Q-8376 with a 16.9 burn
time and 1883 pounds of thrustt Motor by...
<https://www.youtube.com/watch?v=eeOVhQKnTfg>
On Sunday, September 17, 2017 6:57 PM, Mike Smith <smittypwr@xxxxxxxxx>
wrote:
Tell me what you think of this find: (see attached photos) It's a
stainless steel nozzle disguised as a Wilton's cake-decorating tip. Found
at my local craft store for 99 cents. It's .714" wide at the base, 1.24"
high from base to apex. 15 degree angle from center axis. Steel is .01
thick. Since it is so smooth, I plan on using it to mold nozzles instead of
turning a wooden mold on my lathe. But what do you think of the possibility
of using it in a small motor?
