Dear All , I happened to look into the Step Down Converters from MonothilicPower. The following is the statement made in the webpage: MPS presents the MP2309 and MP2307 23V synchronous step-down regulators. With an output current rating of 1A and 3A respectively, the MP2309 and MP2307 are pin compatible with the 2A MP2305, forming a power management solution that can easily scale from 1A to 3A without circuit board re-design. http://www.monolithicpower.com/fpga_xilinx_spartan.htm Could anyone please explain how come this is feasible. Following are the general rules for a step Down converter: 1) Since the input capacitor (C1) absorbs the input switching current it requires an adequate ripple current rating. 2) The worst-case condition occurs at VIN = 2VOUT,where IC1 = ILOAD/2. 3) Inductor should be chosen that it will not saturate under the maximum inductor peak current. The peak inductor current hence is dependent on the Load Current. Hence how is that if we want to change to a different load requirement, only a Monolithic power solution Chip change is enough. How come the external components remain with the same rating for different loads. Please can anyone explain this . It will be of great learning to us here. Thanks Regards Vivek. DISCLAIMER: ----------------------------------------------------------------------------------------------------------------------- The contents of this e-mail and any attachment(s) are confidential and intended for the named recipient(s) only. It shall not attach any liability on the originator or HCL or its affiliates. Any views or opinions presented in this email are solely those of the author and may not necessarily reflect the opinions of HCL or its affiliates. Any form of reproduction, dissemination, copying, disclosure, modification, distribution and / or publication of this message without the prior written consent of the author of this e-mail is strictly prohibited. If you have received this email in error please delete it and notify the sender immediately. Before opening any mail and attachments please check them for viruses and defect. ----------------------------------------------------------------------------------------------------------------------- ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu