Hai I have one doubt on the TMS320C6414 DSP.here JTAG port used for both boundary scan emulator operation of DSP.In emulator related document they have mentioned, the JTAG TRST pin should not be connected to pull up.This pin having internal pull down on the DSP chip itself.but boundary scan mode they have mentioned TRST pin need to be connected to pull up. My doubt is if we provide the pull-up for TRST pin, weather it affect the emulator operation? Regards Gopalakrishnan.S Project Engineer Wipro Technologies Lakshmi buliding,Begumpet, Secunderabad-500003 Tel-91-40-27906008,Ext-4625 Fax-91-40-27907123 -- Attached file included as plaintext by Ecartis -- -- File: InterScan_Disclaimer.txt **************************Disclaimer************************************************** Information contained in this E-MAIL being proprietary to Wipro Limited is 'privileged' and 'confidential' and intended for use only by the individual or entity to which it is addressed. You are notified that any use, copying or dissemination of the information contained in the E-MAIL in any manner whatsoever is strictly prohibited. **************************************************************************************** ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu