Hello,=20 In SMPTE RP-184, "Specification of Jitter in Bit-Serial Digital Systems", I have a question in regards to Figure-5 and Table-3, "Intrinsic and Output Jitter", both of which are on pg-6. I understand that the F3-F4 band is a subset of=20 the F1-F4 band, and that these are the pass bands for alignment and timng jitter respectively.=20 Would it be a correct interpretation to infer a **composite** jitter filter such that we increase=20 the attenuation from A1 to A2 as the frequency=20 approaches F3 from F1 (@ -20dB per decade)? Thx, Jim - Jim Antonellis=20 janton@xxxxxxxxxxxx Broadcom Corp www.broadcom.com Office: 978.689.1669 Cell: 978.618.4745 This message and any attachments are Confidential and may be Legally Privileged.=20 It is intended solely for the addressee. If you are not the intended recipient,=20 please delete this message from your system and notify us immediately.=20 Any dis-closure, copying, distribution or action taken or omitted to be taken=20 by an unintended recipient in reliance on this message is prohibited and may=20 be unlawful. ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu