Hi, Look at this part: DS90CP22 - 2X2 800 Mbps LVDS Crosspoint Switch from National Semiconductor. It is configurable as 2:1 mux, 1:2 demux, repeater or 1:2 signal splitter Regards Eugene Ivanov Accelight Networks -----Original Message----- From: pikeda@xxxxxxxxxxx [mailto:pikeda@xxxxxxxxxxx] Sent: May 1, 2002 3:03 PM To: SI-List Discussion Group Subject: [SI-LIST] Diff 2 Load Hello Guru's, Will a termination at the end of a daisy chain work for a dual load differential clock @156.25MHz seperated by about .6" minimum, or must a differential clock driver be used? If so what would be a maximum stub for the first load? Thanks for any suggestions. Paul Ikeda ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu