Hi Oleg , There is a setting in the Artwork film control you can select ''Use Aperture Rotation''. ( Presuming you are using gerber with an aperture list and not 274x ) Mike Barham - - - - - - - - - - - "Kipnis, Oleg" <Oleg.Kipnis@xxxxxxxxxx> on 18/11/2002 17:39:37 Please respond to Oleg.Kipnis@xxxxxxxxxx Sent by: "Kipnis, Oleg" <Oleg.Kipnis@xxxxxxxxxx> To: "'si-list @freelists.org'" <si-list@xxxxxxxxxxxxx> cc: (Mike Barham/GB/3Com) Subject: [SI-LIST] Allegro Question Hello Allegro Gurus, On Allegro (v13.5) I have to create Oblong padstacks and put pins on 45,135 (and so on) degrees.. When I'm creating gerber program says: "Artwork can't use standard geometries to flash these odd-rotated (not 0,90,270,180) pads". Any suggestions. Thank you on advance Regards,Oleg Kipnis PCB Designer Smart Modular Technologies A SOLECTRON COMPANY (510) 624-8286 ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu