Richard Harshaw wrote:
Hi, All. I have a Celestron C11 on a CI700 mount with an NGC-Max digital setting circle control. I used to use it with an old Laptop using TheSky 6.0. My old laptop had a serial port on it, so the RS-232 cable was a direct connect. All was going well until my laptop entered a black hole this summer. The new one, of course, does not have a serial port ("What's that?" asked the clerk.) So I got one of Thomas Hilton's RS-232 to USB converter adapters and installed it on my new laptop (a Dell Vostro). I set up TheSky's Telescope setup dialogs as I had before, but now when I sync the laptop with the scope, strange things happen. At sync, the Warp (or "difference") is in good agreement with the NGC Max. But when I start to slew, the RA and DEC readouts (in Telescope, Digital Setting Circle mode in TheSky) change WAY too fast. For instance, a slew of 30 minutes in RA causes a 4 HOUR change in the readout, and a slew of 20 degrees in DEC causes a 40 or 50 degree change in the readout. I am at a loss to figure this out, having tried all sorts of tweaks in thesetup dialog. My encoders are hi res (4,000 tics per rev).Anybody have any suggestions?
Check your comms rate. It's probably set to 115K, try dropping it to 38.4K, or even 9600.
Tim