Hi Greg, great to see you on Saturday. How was the balloon fiesta? I've
searched my emails and can't find one from you with the name of the trailer
vendor. Would you mind resending?
Thanks,
Sam
-----Original Message-----
From: roc-chat-bounce@xxxxxxxxxxxxx <roc-chat-bounce@xxxxxxxxxxxxx> On Behalf
Of Gregg Halligan (Redacted sender "tgh218" for DMARC)
Sent: Wednesday, September 11, 2019 7:18 PM
To: roc-chat@xxxxxxxxxxxxx
Subject: [roc-chat] Re: shear pins
Depends on the fit and motor.
Won’t hurt to have holes for them
Gregg
Sent from my iPhone
On Sep 11, 2019, at 2:47 PM, Sam Atwood <twoatwoods@xxxxxxxxx> wrote:
I'm getting a 3" dual-deploy rocket ready for a J flight on Saturday. I have
shear pins (nylon screws) for the nose cone/main chute section to make sure
there is no drag separation. I can't remember whether or not I also need them
for the lower/drogue section. Any thoughts?
Thanks,
Sam Atwood
--
ROC-Chat mailing list
roc-chat@xxxxxxxxxxxxx
//www.freelists.org/list/roc-chat