ParaLite. Think there were made by Leading Edge Rocketry but haven't seen them
around for a while. It was kinda spendy IIRC.
On May 16, 2018, at 10:13 AM, Lesnick, Mike <mikel@xxxxxxxxxxx> wrote:
Hi Out There,
I think I asked this question a while back so forgive me if I missed the
answer. Does anyone know the name of the company that sells a light that
attached to the parachute for night flights?? I think it was called the
para light or something like that ?
Michael Lesnick
Axiom Healthcare Group
AXIOM Mailing Address
9504 Topanga Canyon Blvd
Chatsworth, CA 91311
Cell 714-323-5968
Office 714-594-5720
Fax 714-656-0535
"All That We Can Be"
Send Me Large Files
If you have Large Files or A Large number of files please Use The following
Share File Link:
https://axiomhealthcare.sharefile.com/r-raceddbc89c849fd8
From: roc-chat-bounce@xxxxxxxxxxxxx [mailto:roc-chat-bounce@xxxxxxxxxxxxx] On ;
Behalf Of Richard Dierking
Sent: Wednesday, May 16, 2018 10:10 AM
To: roc-chat@xxxxxxxxxxxxx
Subject: [roc-chat] Re: Building AT M1600R Motor
Thank you. Yes, I've used O-ring spacers between grains in the past as well.
However, this is not stated in the directions, and more importantly, just
checked with Wildman Tim, and he said no O-rings needed between grains on
this motor. The extra O-rings may be for using with CTI hardware.
Wish that there was some mention of the extra O-rings in the directions that
came with the motor, but that sometimes happens.
Richard
On May 16, 2018, at 9:42 AM, Onawahya Jones <wolfmaw@xxxxxxxxx> wrote:
When I built my AT m1780 (75mm), there were o-rings that were placed between
the grains. I worked with others who had sent up the same motor before and
they made sure I included the o-rings between the grains. Be sure that you
have the needed o-rings for the forward seal disk, the forward closure, and
the aft closure.
On Wed, May 16, 2018 at 9:26 AM, Richard Dierking <applerocketry@xxxxxxxxx>
wrote:
I’m getting ready for LDRS and my L3 flight attempt. I’m planning on using a
M1600R motor. It’s a 98mm 3 grain. I noticed 2 extra small diameter O-rings
in the build kit that are not mentioned in the directions. Are these O-rings
to be placed between the grains?
BTW: just thinking, what difference really would they make for this motor?
If you have experience with this motor, I would appreciate your advice.
Thank you,
Richard Dierking
TRA #11366, L2
--
ROC-Chat mailing list
roc-chat@xxxxxxxxxxxxx
//www.freelists.org/list/roc-chat