Hi Tim and Richard,Thanks for the instructions on lubricating the focus mechanism. I'll on it when I finish this run of prints.
The one thing that causes anxiety is when Tim mentions loosening the rods and guides and then having to realign the whole thing. Doesn't sound like "fun" to me ;)
What kind of laser alignement tool do you use? I've never had a problem with alignement so I am reluctant to go there. "If it ain't broke...."
Thanks again for the info; most helpful. Regards, Bogdan Tim Daneliuk wrote:
Bogdan Karasek wrote:Hi all, I'm addressing to the owners of Omega D-2 enlargers. I'm working in the darkroom and notice that the focus knob and rod are making a squeaky sound when I focus and I'm finding that I'm having to put a bit more effort into turning the knob than I should be. I'm thinking that the focusing mechanism needs some lubrication. Any suggestions as to type of lubrication I should use, oil, light, thick, white grease.....??? Where should I place it.... Quantity....??? All suggestions are welcome. Thank you.0) This is gonna be a little messy - lay down some thick newspaper under the general area of work. Loosen the rods and guides as needed to get at everything. 1) Clean the rods exterior and the groove along the back - naptha or lighter fluid will work, though it is not a great idea to be in constant skin contact with the stuff, so wear gloves (and eye protection ... always). 2) I lube the guide slots in the back with a light lithium white grease. I lube the exterior of the rods with a VERY light coating of high quality fine machine oil. I apply the grease into the groove sparingly with a Q-Tip and wipe the rods down with a cotton rag lightly soaked in the oil. 3) Be sure to check to adjust the tension on the spring plates. 4) Reassemble and tighten - this is the really, really fun part. Make sure the lens mount, rods, and so on are properly aligned. I use a laser alignment tool. BTW, I found that replacing those silly slot head bolts that came with the D-2 with hex head bolts makes it waaaaay easier to tweak in an alignment setting. HTH, I've-Spent-Too-Much-Time-Rebuilding-D-IIs-Ly Yours, ---------------------------------------------------------------------------- Tim Daneliuk tundra@xxxxxxxxxxxxxx PGP Key: http://www.tundraware.com/PGP/ ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. __________ Information from ESET NOD32 Antivirus, version of virus signature database 4620 (20091118) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com
============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.