Hi Jim, Sounds promising will email mail you off list for email and add if required. I have the single ens type. Best wishes Gerry On 29/01/2011 17:44, Jim Brick wrote:
I have ZBE enlargers with closed loop heads which are basically DeVere 504 based. I might have a spare manual and if I do, I'll need your address. I don't think, however, it answers your question. Oh, do you have the Auto version (3-lens turret) or the manual, single lens version ? Other than the motherboard, the electronics are very different.Jim Brick Sunnyvale, CA http://www.photomojo.org/vip.swf On Jan 29, 2011, at 9:23 AM, GERRY (GPCX) wrote:Hi Bob, SORRY all should have said I am in the UK.I could try Odyssey Sales in UK, but they tend to be expensive.e,.g., just bought a bulb for the 504, it took a week to arrive from Odyssey Sales (apparently they did not raise an invoice for my first telephone order), also it was over twice as expensive as one by GE sold on eBay (with free post). So, I hope someone might had the manual and some other suggestions.Most kind of you to reply, and thanks. Gerry On 29/01/2011 17:15, Bob Younger wrote:You can get most anything DeVere from KHB in Canada. Not free, but not exorbitant, either.BobOn Sat, Jan 29, 2011 at 8:53 AM, GERRY (GPCX) <gpcx@xxxxxxxxxxxx <mailto:gpcx@xxxxxxxxxxxx>> wrote:Hi All, Does anyone have a Devere504 with closed loop head? If you do you use one, would you have the manual for the Power Supply and filter/timer keyboard controller made by ZBE inc. please, or any advice :-) ? The power supply was had a label underneath (none on front, just two switches and a push button) reads RST Developments repaired by CANLEY. My goal is to use a Analyzer Pro (RH Designs) to control the head, and wonder if that analyzer can be attached to control the head, with or without the ZBE keyboard? Best wishes, Gerry