The following new message has been posted on Phorm Support Forum at <http://www.phorm.com/support/>. *************************************************************************** MESSAGE: (#2989) Re: How do I disable $PHORM_TMPL <http://www.phorm.com/support/?rev=2989> AUTHOR: Kally DATE: July 17, 2003 at 4:29 a.m. EST Reply To: (#2988) Re: How do I disable $PHORM_TMPL Author: Patrick O'Hara Date: July 17, 2003 at 1:33 a.m. EST $PHORM_TO = "orders@xxxxxxxxxxxx "; > The bit in bold above needs to be removed as this is > causing Phorm to try send an email to that address. Thank you Patrick. I had actually already found that and deleted from my config files. But instead of closing the browser window I was testing my form and starting fresh, I was using the back arrow and reusing the first page (of my multi-part form) to save some typing. So it was holding tht variable in memory and I could not figure out what was happening. So I saved a few typing strokes and wasted hours trying to figure out the problem after I had already fixed it!! Thanks again! Kally *************************************************************************** This is an automatically-generated notice. If you'd like to be removed from the mailing list, please visit Phorm Support Forum at <http://www.phorm.com/support/>, or send your request to webbbs@xxxxxxxxxx If you wish to respond to this message, please post your response directly to the board. Thank you! ------------------------------------------------- You are receiving this message because you are subscribed to the Phorm mailing list. To send messages to the mailing list, simply send email to phorm@xxxxxxxxxxxxx from the address you have subscribed. You may unsubscribe from the list by sending email to phorm-request@xxxxxxxxxxxxx with 'unsubscribe' in the SUBJECT field.