The following new message has been posted on Phorm Support Forum at <http://www.phorm.com/support/>. *************************************************************************** MESSAGE: (#3654) Re: CGI Error: No HTTP Headers sent <http://www.phorm.com/support/?rev=3654> AUTHOR: Holotech DATE: January 30, 2004 at 10:39 a.m. EST Reply To: (#3640) Re: CGI Error: No HTTP Headers sent Author: Scott Dye Date: January 27, 2004 at 3:11 p.m. EST > If I remove the local config settings and use the > quickconfig instead, it works using the default ack > and email, but when I try to add the local > form-specific config setup, I get blank. That certainly sounds strange. Try setting debug flags 2 and 3 and see if that produces any output. If not, email me your config file and I'll see what I can see. *************************************************************************** This is an automatically-generated notice. If you'd like to be removed from the mailing list, please visit Phorm Support Forum at <http://www.phorm.com/support/>, or send your request to webbbs@xxxxxxxxxx If you wish to respond to this message, please post your response directly to the board. Thank you! ------------------------------------------------- You are receiving this message because you are subscribed to the Phorm mailing list. To send messages to the mailing list, simply send email to phorm@xxxxxxxxxxxxx from the address you have subscribed. You may unsubscribe from the list by sending email to phorm-request@xxxxxxxxxxxxx with 'unsubscribe' in the SUBJECT field.