Here's a question I recently received, that I'm answering on the new mailing list:
Mike, I've obtained the ring PCBs and parts and am ready to assemble the rings. Although it looks pretty straight-forward, you had offered to send a detailed photo. Could you do this so that I minimize mistakes?
Thanks a lot.
Dan Valente
The photos are attached. Remember that for the top of the flight arena, the board is used only for mechanical, not electrical purposes. To be safe, I have just cut all of the lines connecting to the make headers using a Dremel - you might notice there are small white lines of the top PCB.
Good luck!
Attachment:
arena_bottom.jpg
Description: JPEG image
Attachment:
arena_top.jpg
Description: JPEG image