I am trying to generate a grid for onera m6 wing. I took a surface grid in the form of plot3d file. I am able to read it into ogen. Now I am trying to generate volume grid using "mapping from normals" but I get an error that the mapping wing-surface is unknown. I am sure I am making a silly mistake but I am not able to figure it out. I have attached the files. Can you take a look please. Thanks praveen On Sat, Jul 18, 2009 at 9:22 AM, Bill Henshaw <henshaw@xxxxxxxx> wrote: > Dear Praveen, > > I guess the closest example that we have is in the > sail for the submarine (Overture/sampleGrids/sub.cmd) > which uses the cross-section mapping. Of course the > trailing edge and end cap are the difficult parts > to deal with. > > We should have a better example distributed with > Overture so if you are able to create something and > are willing to share it with us that would be great. > > Regards, > Bill. > >
* * Takes a plot3d file for a wing surface grid * create mappings read plot3d file surf.dat view mappings surf.dat-grid0 pause exit * DataPointMapping build from a mapping surf.dat-grid0 mappingName wing-surface exit * change a mapping wing-surface boundary conditions 1 1 1 1 -1 -1 pause exit * * check mapping * wing-surface * exit * mapping from normals mappingName wing-grid extend normals from which mapping? wing-surface normal distance 0.5 pause exit * exit this menu * generate an overlapping grid wing-grid done choosing mappings change parameters ghost points all 2 2 2 2 2 2 exit compute overlap exit * save an overlapping grid wing.hdf wing exit