[modeleng] Re: Fryolux solder paint
- From: "R.L. Roebuck" <rlr20@xxxxxxxxxxxxx>
- To: modeleng@xxxxxxxxxxxxx
- Date: Fri, 27 Aug 2004 15:30:00 +0100 (BST)
Cheers Richard,
Thats sounds very promising. Can I ask, did you just give it a rinse to
wash it off afterwards, or did you go to any additional effort?
Yours,
Rich.
PS I'll take you're advice, and go easy on the Fryolux spread sandwiches.
On Fri, 27 Aug 2004, Richard Harvey wrote:
> Hi All
> I used Fryolux for all the tender work on the King including the beading. It
> had it recommended to me by a very experienced model engineer and I'm glad
> he did. Despite the warnings its easy and a treat to use, especially for a
> newcomer such as myself. I wouldn't recommend you lick your fingers after
> using it....but hey! Simple precautions are fine.
>
> Hope it helps
> Richard H
>
>
> -----Original Message-----
> From: modeleng-bounce@xxxxxxxxxxxxx [mailto:modeleng-bounce@xxxxxxxxxxxxx]On
> Behalf Of R.L. Roebuck
> Sent: 27 August 2004 13:10
> To: modeleng@xxxxxxxxxxxxx
> Subject: [modeleng] Fryolux solder paint
>
> Hi there All,
>
> Quick question for the list - I'm considering trying to use Fryolux solder
> paint to seal up my loco tanks (ie paint it on, assemble the bits and heat
> it up, ading a bit of extra solder and flux as need be).
>
> Has anyone tried using Fryolux before, and had good or bad experiences?
>
> Also, the number of warnings on the side of the pot don't bode well, is
> there anything particularly bad about it, or is it just like using lead
> solder and bakers fluid?
>
> One other thing, it says its grade K on the side of the pot - is this
> relevant, anyone know what it means?
>
>
> Yours,
>
>
> Rich.
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
> line.
>
>
> MODEL ENGINEERING DISCUSSION LIST.
>
> To UNSUBSCRIBE from this list, send a blank email to,
> modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject
> line.
>
>
MODEL ENGINEERING DISCUSSION LIST.
To UNSUBSCRIBE from this list, send a blank email to,
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.
Other related posts:
