these LPFs have good attenuation around the stop point but after some increase again allow why not we check behavior of LPF, 50% above the band under consideration, say upto23MHz for a 15mhZ LPF. On Thu, Jan 30, 2014 at 9:47 PM, Mark G0MGX <mark.g0mgx@xxxxxxxxx> wrote: > Here are some outputs as promised; it is definitely the 30MHz LPF in > circuit above 15MHz, but I am surprised by the amplitude of the LO even > when it is as high as 49MHz. > > I will check, check, check! > > Mark > > > > > > On 30/01/2014 16:05, Ashhar Farhan wrote: > > mark, > note that the audio is 'hissier' than a usual transceiver, this is due to > larger bandwidth. you could try a 0.1 across the two ends of the volume > control to reduce the bandwidth. > > - farhan > > > On Thu, Jan 30, 2014 at 5:44 PM, Mark G0MGX <mark.g0mgx@xxxxxxxxx> wrote: > >> I'm very pleased with how it sounds; can't wait for the 1st QSO! >> >> I've just done some experiments this morning with a new >> design/replacement for the 15MHz LPF, which I can't get quite right as >> Farhan designed: >> >> http://g0mgx.blogspot.co.uk/2014/01/minima-remaking-15mhz-lpf.html >> >> I'll do the sweep requested later today as I move onto TX testing... >> >> Mark >> G0MGX >> >> >> On 30/01/2014 10:33, jerry@xxxxxxxxxxxxxxxx wrote: >> >>> Good job Mark, the audio sounds great.I can't wait to finish mine. Jerry >>> K5LRU >>> >>> >>> -------- Original Message -------- >>> Subject: [minima] Re: My Minima is Alive and well >>> From: "Steve VK2SJA" <vk2sja@xxxxxxxxxxx> >>> Date: Thu, January 30, 2014 4:13 am >>> To: minima@xxxxxxxxxxxxx >>> >>> Way to go Mark! >>> >>> I knew you'd finish before I even turned on the iron!! >>> >>> Good audio on the video. Thanks for posting. >>> >>> 73, Steve. >>> >>> >>> >>> Morning Team >>>> >>>> An update from me, RX demo video here: >>>> >>>> http://g0mgx.blogspot.co.uk/2014/01/my-minima-is-alive-and-well.html >>>> >>>> the RX sounds great! >>>> >>>> Mark >>>> G0MGX >>>> >>>> >>>> >> >> > > -- Regards Sarma