I am bringing up an EP9312-based prototype that is essentially a subset of the EDB9312 design. The only major difference is that this prototype has 16-bit wide flash unlike the the 32-bit flash of the EDB9312. I have modified the redboot and kernel patches to reflect this change. I am able to successfully download and flash kernel and ramdisk images (using serial, not network). When I try to "exec", I don't get a linux prompt, just what appears to be some sort of redboot message (see the last line of the dump). I am trying the run using a serial console. +EP93xx - no EEPROM, static ESA, or RedBoot config option. No network interfaces found RedBoot(tm) bootstrap and debug environment [ROMRAM] Non-certified release, version v2_0 - built 22:08:07, May 24 2005 Platform: Cirrus Logic EDB9312 Board (ARM920T) Rev A Copyright (C) 2000, 2001, 2002, Red Hat, Inc. RAM: 0x00000000-0x02000000, 0x00041de8-0x01fdd000 available FLASH: 0x60000000 - 0x61000000, 128 blocks of 0x00020000 bytes each. == Executing boot script in 5.000 seconds - enter ^C to abort RedBoot> fis load ramdisk.gz RedBoot> fis load zImage RedBoot> exec -r 0x1000000 -c "console=ttyAM0" 0x218000 Using base address 0x00218000 and length 0x000ca0ac $T0a0f:d0960000;0d:5c910300;#81 What does this final line indicate? I have tried various exec options but always get the same message. Thanks for any help you can provide. Paul Whalley __________________________________ Do you Yahoo!? Yahoo! Small Business - Try our new Resources site http://smallbusiness.yahoo.com/resources/