Hey all.
This is probably a noob question, but I am trying to get klipper flashed to my
raspberry pi. I am following the instructions on the klipper web page.
Everything was going well until I tried to run the "ls /dev/serial/by-id/*"
command. It came back as "ls: cannot access '/dev/serial/by-id/*': No such
file or directory" I am connected wireless through Putty on Windows 10. I very
much appreciate any suggestions! Also, the latest version of Octoprint was
flashed to the micro sd card before I started the klipper install (as per the
instructions).
Thanks for any assistance,
Pat