Hi guys,
Installing Klipper was a breeze, but I got stuck getting everything
configured so that my printer works again. I modified the generic-rambo.cfg
according to the schematic at
https://github.com/ultimachine/Mini-Rambo/blob/1.3a/board/Project%20Outputs%20for%20Mini-Rambo/Mini-Rambo.PDF
to work for my Prusa with a mini rambo 1.3, but none of the motors work
even though they just did with the Prusa firmware and Octoprint.
When it's trying to home, the motors have some resistance which leads me
believe that the enable pins are correct. When they are supposed to be
moving there is a very faint humming sound coming from the appropriate
motor. Everything else in the Config_Checks documents works perfectly well.
The hardware worked fine, then I changed the software and the hardware
doesn't work anymore, which leads me to believe that it's a software
problem.
I've been banging my head against a wall for two evenings, so any advice
would be appreciated.
Thanks
