I get 404 error -Ron -- Ron Rosson ron@xxxxxxxxxxxxx http://www.oneinsane.net > From: themacuser <themacuser@xxxxxxxxx> > Reply-To: <kismac@xxxxxxxxxxxxx> > Date: Tue, 11 Oct 2005 13:47:14 +0930 > To: <kismac@xxxxxxxxxxxxx> > Subject: [kismac] Re: Re(2): Decrypt Output > > http://gm2.ath.cx/open_ethereal.zip > Patch for KisMac to open ethereal. > > On 07/10/2005, at 12:24 AM, Ron Rosson wrote: > >> This little gem will help you start ethereal. >> >> http://www.wordtech-software.com/aquaethereal.html >> -- >> Ron Rosson >> ron@xxxxxxxxxxxxx >> http://www.oneinsane.net >> >> >> >>> From: Michael Peth <michaelpeth@xxxxxxxxx> >>> Reply-To: <kismac@xxxxxxxxxxxxx> >>> Date: Thu, 06 Oct 2005 15:20:12 +0200 >>> To: <kismac@xxxxxxxxxxxxx> >>> Subject: [kismac] Re: Re(2): Decrypt Output >>> >>> So I got ethereal installed via fink but I get (ethereal:11930): >>> Gtk-WARNING **: cannot open display: >>> However, tethereal works fine in darwin. When I use tethereal -r >>> OUTPUTFILE it reads all the packets but doesn't spit out a key at the >>> end. Any sugggetions ? >>> >>> Mathieu Masseboeuf wrote: >>> >>> >>>> Hi, >>>> >>>> There are compilation issues if you run 10.4, those are fixed in >>>> CVS. >>>> If it's your case, either get a pre-compiled package or build >>>> from CVS. >>>> >>>> Mathieu >>>> >>>> On 6 oct. 05, at 14:45, Alexis Ramel wrote: >>>> >>>> >>>>> Or.. fink ! >>>>> http://fink.sf.net/ >>>>> >>>>> The same as DarwinPorts, pick the one you want. >>>>> >>>> >>>> >>>> >>>> >>>> >>> >>> >>> >> >> >> >> > > >