Re: Quicken and JFW6
- From: "Stan Holdeman" <sholdeman@xxxxxxx>
- To: <jfw@xxxxxxxxxxxxx>
- Date: Wed, 7 Sep 2005 21:29:23 -0500
Loreal: I found the following in a message I kept.
Stan
===
----- Original Message -----
From: "Chris Jenkins" <saveup@xxxxxxxxxxxxxx>
To: <jfw@xxxxxxxxxxxxx>
Sent: Tuesday, August 09, 2005 8:50 PM
Subject: RE: Quicken 2004/2005 support
Hello Jeff.
I'm successfully using Quicken 2005 with Jay FW version 6.0. I had to
write
a switch to configuration statement and place it in the Otto load event
function so that Jaws would know to load the Quicken 2003 configuration
files. To do this follow the following steps.
1 open Quicken 2005
2 opened the script manager
3 either right in are copy and paste the following three lines
Function AutoStartEvent ()
SwitchToConfiguration ("quicken")
EndFunction
4 press control +s to compile the script source.
It's not the best in the world but it works well enough for me. I hope it
works well enough for you.
I hope this helps.
Chris.
--
To post a message to the list, send it to jfw@xxxxxxxxxxxxx
To unsubscribe from this mailing list, send a message to
jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line.
Archives located at: //www.freelists.org/archives/jfw
If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx
Other related posts:
