Where is the screen echo setting?
Thanks
Sent from my iPhone
On Feb 2, 2017, at 12:02 PM, Bissett, Tom <tom.bissett@xxxxxxx> wrote:__________�
When I am using PCom I use it with screen echo turned to none. Then I
monitor something on the screen that I can use as a prompt to know where I am.
Regards
Tom Bisset
-----Original Message-----
From: jawsscripts-bounce@xxxxxxxxxxxxx
[mailto:jawsscripts-bounce@xxxxxxxxxxxxx] On Behalf Of Cory Woodrow
Sent: Thursday, February 02, 2017 11:19 AM
To: JawsScripts Mailing List
Subject: [jawsscripts] PCOMM / 3270 scripting
Hi
There have been lots of threads in the past. I've reviewed everything I can
find but haven't had any luck, hoping someone can help.
I need to monitor the IBM PCOMM screen for changes however it is just too
talky. I am using blinking underscore cursor and screen coordinates are
turned off.
Newtextevent is constantly getting activity. I have tried limiting it via
single character checks as mentioned in a previous thread but it still
creates too much activity. Going to new screens are awful - it just keeps
triggering newtextevent over and over. It happens randomly a lot - just out
of the blue.
I really only need it to trigger or to know when a screen changes so maybe
setting a frame? I haven't really worked with them yet though.
Any ideas or thoughts greatly appreciated
__________???
View the list's information and change your settings at
//www.freelists.org/list/jawsscripts
__________�
View the list's information and change your settings at
//www.freelists.org/list/jawsscripts
