Thanks Jim, I thought about that, but the number of rows in the table is dynamic. I also tried the EndOfTable function, but couldn't get the syntax of the While statement down. ----- Original Message ----- From: "Jim Snowbarger" <snowman@xxxxxxxxxxxxxxxx> To: <jawsscripts@xxxxxxxxxxxxx> Sent: Monday, December 29, 2014 3:44 PM Subject: [jawsscripts] Re: Looping > Can't you obtain the row or column count for the table, and just loop > until > all cells are processed? > > Another less elegant way is to capture the coordinates of the current > cell, > try to move to the next cell, then get the cords again and see if they > changed. > > > -----Original Message----- > From: jawsscripts-bounce@xxxxxxxxxxxxx > [mailto:jawsscripts-bounce@xxxxxxxxxxxxx] On Behalf Of Marcus Canaday > Sent: Monday, December 29, 2014 9:35 AM > To: jawsscripts@xxxxxxxxxxxxx > Subject: [jawsscripts] Looping > > Good morning, > I've developed a script that loops until certain conditions on a web page > are identified. To avoid an infinite loop, I've set the number of > iterations > to 30. This works fine, but I'd like the loop to end when it reaches the > end > of a table if the conditions are not found. I've not been able to make > this > work ... any suggestions? Thanks. > > > > > --- > This email is free from viruses and malware because avast! Antivirus > protection is active. > http://www.avast.com > > __________� > > View the list's information and change your settings at > //www.freelists.org/list/jawsscripts > > > > > __________� > > View the list's information and change your settings at > //www.freelists.org/list/jawsscripts > --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com __________� View the list's information and change your settings at //www.freelists.org/list/jawsscripts