[PCB_FORUM] Re: non allegro rs274x gerbers into allegro? SOLVED
- From: "Dharma Kemp-Bresett" <dharma@xxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Fri, 4 Apr 2008 11:12:29 -0400
Hi Everyone,
I appreciate all the responses. What I ended up doing was importing the
gerbers into valor and exporting DXF from valor. Those I was able to bring
into allegro. This method will not work for other situations though and I
have not had a chance to try some of the offered solutions, therefore, I
have saved all the emails for future reference. :-)
Thanks again everyone!
Dharma
KAW/USA Ltd.
39 Simon Street, #4
Nashua, NH 03060
603-886-8711 x212
603-881-8763 fax
Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.
_____
From: Dharma Kemp-Bresett [mailto:dharma@xxxxxxx]
Sent: Thursday, April 03, 2008 5:51 PM
To: 'icu-pcb-forum@xxxxxxxxxxxxx'
Subject: non allegro rs274x gerbers into allegro?
Hi Everyone,
Is there a way to get 274x gerbers output from some other CAD/CAM program to
read into allegro? The general error I seem to be getting is "N codes not
supported" I have tried everything I can think of and none of it is working.
Some of you must have run into this before.....?
Thanks in advance,
Dharma
KAW/USA Ltd.
39 Simon Street, #4
Nashua, NH 03060
603-886-8711 x212
603-881-8763 fax
Confidentiality Notice: This email and any accompanying documents contain
information that is confidential, privileged or exempt from disclosure under
applicable law and is intended for the exclusive use of the addressee. This
information is private and protected by law. If you are not the intended
recipient, or have received this email in error, you are hereby notified
that any disclosure, copying, distribution or use of the contents of this
document in any manner is strictly prohibited.
Other related posts:
- » [PCB_FORUM] Re: non allegro rs274x gerbers into allegro? SOLVED
