Thanks, Randy. Sandy
Bye, Randy W wrote:
Hi Sandy,
This forum is only for questions/discussions that are regarding Cadence PCB tools.
Regards,
Randy
Randy Bye
PCB Engineering
UNISYS , Imagine it. Done.
PO Box 64942
St. Paul MN. 55164
MS: 4713
Voice (651)635-3998
Fax (651)635-6329
E-mail: randy.bye@xxxxxxxxxx
THIS COMMUNICATION MAY CONTAIN CONFIDENTIAL AND/OR OTHERWISE PROPRIETARY MATERIAL and is thus for use only by the intended recipient. If you received this in error, please contact the sender and delete the e-mail and its attachments from all computers.
------------------------------------------------------------------------
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of MR_STEW
Sent: Friday, August 05, 2005 9:52 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: gloss 45's to arcs on the diff-pairs
I'm new to this forum. What software pkg. are you using ? I use PADS 5.01 and PCAD2002 and I don't recognize the term "gloss".
Thanks,
Sandy
William Gerner wrote:
I seem to recall that gloss wouldn't touch nets having certain types of constraints. I believe it was any kind of delay (length) controls.
This is a bit crude, but you could make a copy of the .brd file and in the copy, strip any delay constraints, run gloss, then clip the diff pair routes into the constrained .brd file. You might find you have to delete any diff pair uncoupled length and phase tolerance info also.
No guarantees on this as I have not glossed routes since v14.
Regards,
Bill
Mariani, Stephen wrote:
I have been unable to get the gloss routine to change the 45's to arcs on the diff-pairs. It works on the non-diff-pair connections. Anybody know the secret?
Steve
*Stephen Mariani* *Mercury Computer Systems, Inc.* 199 Riverneck Road Chelmsford, MA 01824 Phone: (978) 967-1855 Cell Phone: (978) 761-4101 Fax: (978) 244-0520 _mailto:smariani@xxxxxxx
