Joe, You won't be able to do a toggle for the the max 45 length with aliases, but you could set up 2 temporary commands like this: funckey F9 "setwindow form.mini;FORM mini max_45_len 9999.00;setwindow pcb" funckey F8 "setwindow form.mini;FORM mini max_45_len 10.00;setwindow pcb" Then in slide , these will set the value you wanted. With any alias or funckey command, you cam look at the journal file and find a command but if it's form related you need the supporting records too. Regards, Barbara Seeger - Cadence Design Systems - 978-262-6578 On Thu, 2008-01-24 at 13:43, Joe.witten wrote: > I'm in Ver15.7 trying to set up a funckey to toggle between slide with a max > 45 length of 10 or 99999. I can't seem to get toggle to work. I am > replying .scr's that achieve this now, but it would be handy to hit F8 and > toggle between 10 and 99999. Can this be done at the command line? > > Thanks, > Joe > > ----------------------------------------------------------- > To subscribe/unsubscribe: > Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx > with a subject of subscribe or unsubscribe > > To view the archives of this list go to > //www.freelists.org/archives/icu-pcb-forum/ > > Problems or Questions: > Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx > ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------