Hi all, I have Kelvin connections in my board, the two connections should run all the way close to the device under test. Without net scheduling spectra / allegro router shorts these pins in the resource pin itself. (i.e without running two lines close to the DUT) but the problem is I have around 300 kelvin connections. Is there anyway I can automate this process of routing. Any suggestions or comments please. Thanks in advance Best Regards Murali Muralidharan Ranganathan JEM America Corp 3000 Laurelview Court Fremont, CA 94538 Phone: 510-683-9234 ext.137 Fax: 510-683-9790 ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------