[PCB_FORUM] Re: FABMaster Version 4.2.D
- From: "Cosentino, Tony" <Tony.Cosentino@xxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Wed, 10 Aug 2005 12:02:53 -0500
Richard,
Mine seems to work without having to copy the .txt files to the project
directory. Having the .txt files in the C:\Program
Files\Fabmaster\cdc2fab\config\ seems to work fine. Go back a recheck
your script files path again to be sure it is typed correctly.
Tony
________________________________
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Richard E
Marion
Sent: Wednesday, August 10, 2005 12:09 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: FABMaster Version 4.2.D
Hello Gary,
Edited the parts.txt.
Set "Extraction Tool" path. Set "Script Files" path.
Went so far as to add "C:\Program Files\Fabmaster\cdc2fab\config\" to
System Variable Path.
Added ".txt" to System Variable Pathext.
Need some more luck, any further recommendations?
Thank you,
Richard
-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gary MacIndoe
Sent: Wednesday, August 10, 2005 11:46 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: FABMaster Version 4.2.D
Hey Richard,
Yeah, FABmaster has a way of biting you, especially if you haven't used
it for a while, or when you change to a new release of Allegro.
1) Install FABmaster, then, if I remember correctly, for 15.x, you
need to edit the "parts.txt" file (typical path "C:\Program
Files\Fabmaster\cdc2fab\config). In this file, if present, remove these
last three lines:
COMP_RATED_CURRENT
COMP_RATED_POWER
COMP_RATED_VOLTAGE
2) Now, launch FABmaster ("Cdc2fab.exe"). Then in the small
CDC2FAB... window, click File -> Configure. The "Extraction Tool" path
should be set to your Cadence directory where Allegro is loaded, down to
the "bin" directory to find the file "extracta.exe". The "Script files"
path should be the path from Step 1) above to the "config" directory.
Good luck!
Gary E. MacIndoe
PCB Design Engineer
Advanced Micro Devices
Longmont, Colorado
________________________________
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Richard E
Marion
Sent: Wednesday, August 10, 2005 9:13 AM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] FABMaster Version 4.2.D
Greetings,
I haven't done a PCB in Allegro for a while and have mostly re-invented
the process.
However, when running FABMaster Version 4.2.D, it cannot locate the
Script files.
Message: "No match for 'Parts.txt' in the search path."
I have tried the default path, and a more local path.
Is this a System Variable Issue (be kind, I haven't done this for a
while!)?
Thank you,
Richard E Marion
169 Little Mill Road Unit 2
Sandown NH 03873-2554
HOME: 603-887-2266
CELL: 603-247-1610
FAX : 603-887-2936
Other related posts:
